SS Upflow HP 4TWR4N-TEM4 2.0T
SS Upflow HP 4TWR4N-TEM4 2.0T
$146.06**
per monthTested and tested for long-lasting performance and reliability. The XR14 heat pump is affordable, high quality, and built to last.
APPLY FOR FINANCING
Trane XR14 Heat Pump
• Woven Spine Fin™ coil
• Climatuff® compressor
Trane TEM4 Air Handler
• ECM blower motor on select models
• Metal Vortica™ blower
• All-aluminum coil
• Galvanized steel metal cabinet
Trane XL824 Color Touchscreen Control
• ENERGY STAR® certified
• Remote Climate Access included**
• Wi-Fi or Ethernet connectivity
• Built in Bridge for Z-Wave devices
• Trane Diagnostics ready
• Used with conventional 24 volt systems
• 5 heat / 2 cool
• 7-day programmable
• 4.3” color display
• Humidity sensor
• Humidifier, ventilation, and dehumidifier control
• 2 filter change reminders
• 5-day weather forecast, local radar & alerts
• Dual Fuel capable
• Allergy and quick clean cycles
• Maintenance reminders
• Customizable home screen
• Embedded diagnostics
• Smart continuous fan
• Color: Designer Silver
AHRI # 209842212
SEER/EER 14.30/11.70
Capacity 23,400
Stages 1
Heat Pump Model # 4TWR4024N1000*
Air Handler Model # TEM4B0B24M21S*
Thermostat Model # TCONT824AS52DB*
Heat Pump
- Furnish and install a new electrical disconnect box with new fuses, wire, and conduit.
- Re-insulate the refrigerant lines outside and in the attic.
- Install conduit around the low-voltage wiring outside to stop sun-rot and rodent damage.
Air Handler
- Furnish and install filter base with easy-access hinged door.
- Furnish and install a new condensate p-trap with vent and clean-out stub.
- Furnish and install a condensate overflow shut-off switch.
- Purge and water test condensate drain line for proof of proper drainage.
- Furnish and install a new sheet-metal transition with flex connector to existing supply drop.
- Duct seal transition connections with low-VOC mastic.
- Seal evaporator cabinet penetrations to prevent known air leakage locations with sealing compound.
- Furnish and install a new 230v appliance cord.
Thermostat
- Configure the control to match the specifications of the equipment installed.
- Setup control for Trane remote diagnostics.
- Setup control with customer defined temperature setpoints and schedules.
- Seal wall penetration behind thermostat with sealing compound.
Other
- On-site inspection to evaluate the particular scope of work.
- Heat load calculation using Manual J software to determine capacity requirements for proper equipment sizing.
- Property protection measures using floor covers and plastic sheeting.
- Existing equipment tear-down, removal, and off-site disposal.
- Exterior work areas broom swept, and interior work areas vacuumed.
- Flow nitrogen through refrigerant lines while brazing to prevent carbon build-up and system contamination.
- Evacuate refrigerant lines to achieve a supporting vacuum at 500 microns or better.
- Equipment start-up and calibration to assure safe, proper, and efficient operation.
- Warranty registration with manufacturer to secure extended warranty terms as needed.
- Process utility rebate application if applicable.
- Quality assurance inspection to check operational performance, safety, and overall installation quality.
- Enrollment into the Cool Club Standard membership to cover the first year of maintenance check-ups.
Every Trane residential unit comes with a Limited Warranty. It covers parts that break because of manufacturer defect, but does not cover the cost of labor.
• 10-year base limited warranty on compressor through Trane
• 10-year base limited warranty on internal functional parts through Trane
Recommended Upgrades
• No labor charges for 10-years
• No refrigerant charges
• No deductibles
• No diagnostic charges (one per year)
• Covers all equipment
• Free to transfer
• Independent 3rd party coverage
• Policy underwritten and insured by DAC
• MERV 11 Media Filter
• 5″ Depth 18 Gauge Metal Painted Cabinet w/ Fully insulated R-4.2 Door
• Air Tite Door Construction with Gasketing and Quarter Turn Easy Open Latch
• Up to 100 times more effective than a standard 1” throwaway filter
• Power door provides easy access to internal components and features a filter status display as well as safety interlocks that automatically shut down the power when the door is opened for maintenance or cleaning
• Removes up to 99.98% @.3 Micron size allergens from the filtered air”
• Allergy and Asthma Friendly® Certified
• Quiet operation
• Helps keep heat outside during summer
• Helps keep heat inside during winter
• Reduces utility costs
• Extends temperature drift time inside
• Reduced cooling load helps HVAC equipment
• Higher R-Value improves resistance to heat flow
• Proper sizing and design provides better air dynamics and air delivery
• 30-year life expectancy
• Even airflow means no more hot and cold spots
• Reduces Odors
• Helps prevent the spread of bacteria and viruses
• Combats toxins and pollutants
• Installs in the duct system to provide improved air quality throughout the entire home
*The Wells Fargo Home Projects credit card is issued by Wells Fargo Bank, N.A., an Equal Housing Lender. Special terms apply to qualifying purchases with approved credit. The special terms APR will continue to apply until all qualifying purchases are paid in full. The monthly payment for this purchase will be the amount that will pay for the purchase in full in equal payments during the promotional (special terms) period. The APR for Purchases will apply to certain fees such as a late payment fee or if you use the card for other transactions. For new accounts, the APR for Purchases is 28.99%. If you are charged interest in any billing cycle, the minimum interest charge will be $1.00. This information is accurate as of 10/20/2021 and is subject to change. For current information, call us at 1-800-431-5921. Offer expires 12/31/22.
**Monthly payment is based on purchase price alone. Credit purchases subject to credit approval. Other transactions may affect the monthly payment.
***Reflects all current manufacturer rebates, utility rebates, and other offers if available.